Відео

As a filter becomes filled with particles, it filters out even smaller particles, beyond specified. & more resistance to flow too.

Thañks.yutube.for.givi ñg.us.the.teacher.he.is.miracle

The.best.teacher.who.knows.to.give.green.ligh.to.beginners.thañks

Hopefully I don’t make anyone cringe too much but how bad is it just to drain and refill if yours has a drain plug?

So how is removing the two bolts that hold the knuckle to the strut not ruining your alignment?? That’s camber.

What purpose is it to spray foam a car? It doesn’t take off any dirt. You still need to hand wash it. I think you wind up using more than three capfuls of soap concentrate

My lift pump just went out on my truck and I've been considering a FASS system and getting some of those collum gauges to monitor my fuel pressure so i don't have to guess about it

My Chevy van has some electrical gremlins that cause a battery drain. This video gives me confidence that I can at least attempt to figure it out such as if the alternator is good. Thank you very much.

Are you putting acid on hubcaps??? Lol... How did I stumble on to this atrocity?

does anyone know if this track is still open i used to train here when i was like 5

I want to replace all cables, nit just positive cable.

How many times a month do you run through a car wash?

Bro when you remove the strut and ball joints it messes alignment up. When we do alignments we loses the strut bolt and the ball joint. We also adjust the outer tie rod end

What is the part number for the cap? I cannot find one anywhere on there website

I’ve got an electrical issue in my Humvee. I can’t tell you how helpful this video has been. This gives me the confidence to check my battery and my wires. Thank you.

My ignition lock cylinder randomly comes out of place and just spins all the way and makes no contact and doesn’t start my truck, I have to fight with it and wiggle it for like 5 minutes like the way your were in the beginning of the video just to get it to start my truck, so I replaced it But noticed it was missing that plastic piece you take out around 10:31 in your video. I put everything back together with the new ignition lock cylinder and still have the same problem I’m guessing that white piece holds it in place and align everything better. Having a hard time looking for that part.

👍👍👍🍦

On my short bed Chevy I just put magna flows dules on no cats but how do you get read of the clapping sound

do u have the link to the oil cap?

@dieselworld do you know if the glow plug light does not come if failed relay 109 in ALH models? Also, do you know if the output of the 109 is supposed to be 12V? I put 12V on the relay input terminals and got no Voltage out of the output terminals. But, my glow plug indicator does come on. So on one hand, it appears that 109 is bad but without the symptom of the indicator. Thanks for the video!

Great Video. I have blown fuses trying to learn how to use my meter and now I see why.

That's amazing. I wish I had a 240 D.

dork

thanks for the video im rebuilding a 1997 k1500 silverado an didnt know how to remove the grill it helped tons thx

One of the simplest and educational clips first use of multimeter. Thankyou.

You were going to measure current?

A laddrr and bucket then rinse is real easy.

Darkness.flys.away.thanks.utube

There is no 'pressure relief valve.' There is no bypass to the bypass, as that's redundant. If that thing fills up, it's NBD, it just stops filtering and full oil flow will automatically be diverted to the full-flow filter. When the full-flow filter fills up, it's bypass takes care of everything.

Hey I stumbled upon your channel and I wonder if you could give me a few pointers in purchasing a car.its a 1975 Mercedes Benz 300D diesel.the odometer is broken and the car looks likes it in good condition.what are somthings i should look for to know if the car is any good.what are some pro and cons about owning a car like that.

Amsoil products are not over priced. You get what you pay for and they are readily available at Napa stores and sometimes the next day on line.

According to Amsoil, the bypass filter is rated at 98.7% efficiency at 2 microns

Need this for 2014 CRV’s. Same bugger thing.

This is great

I'm so sick of this , that's a different setup how many times do I have to retype 1999 dodge fuel filter replacement every year, but 1999 can't find all I want to do is to find out how to change a flippen fuel filter not on a 2001 not a 2000 A 1999 cummins 2500 dodge , I thought thought I heard 2000 was the same not on the sites I've been on been on this for well over an hour , I can't even find how to disconnect the water in fuel sensor it looks fragile and I don't want to break it but I see nothing on how to remove it, no button no slide the next thing I do it to remove that type of sensor connection, just trying to get out of town , and I can't believe not one video on how they come apart you'll find video and they says discount the water in fuel sensor but they don't show you how , the 1st.time I paid.some high price shop to change the filter it.wss 650 for a cheap fuel pump and oil change, that mechanic didn't remove the canister and I believe he ripped me off , he said its not pumping fuel the canister isn't filling up, he told me to look in the canister and he turned the key on and sure enough it wasn't filling up.

Very helpful 😊

I drain my housing first, then do everything you did. And when re-inatalling the cap, you should lube the O-Ring with a tiny amount of clean diesel fuel.

👍 Nice information on this series.

Well here it is 2024 and i just purchased one and its near $575.00 I have 2 trucks 01 4x4/auto and a 01 2x4/6spd HO the Auto was a dog until i put the EZ tune the #2 setting is the one to use for sure!

👍

👍

👍

12valve is the best sounding desel

Thank you sir thanks to your video i was able to replace my cylinde/relay and housing thank you!🙏🏾

👍

👍

Dang it. I thought you were gona rebld the steering pump too. 😂 Thanks still excellent video anyway. Good job. Appreciate you

Do you have a video in which you replace de seal of the top part of the pump??

We need more vids like this

Excellent video